-6-
3
Notice:
. Connect the control box with power on(see step 5) with
solenoid valve, and check the leakage by manual flushing
for several times. Once it is confirmed that there is no
leakage, place the mold sheath onto the valve box and
apply slurry into the crevice around the valve box and
smooth the surface.
a. Please confirm the completion of step 2.
b. Please avoid the damage of the sensor
cover or breaking the cord.
3
.
(
5)
a.
b.
4
. When the slurry turns solid, remove the short screws, pull
out slurry mold, mount the bracket assy
and secure with
long screws.
4
.
5
.
a. Buckle the sensor cover into the wall slightly above
bracket assy.
b. Press the sensor cover down along the wall and fit tightly
into the bracket assy.
c. Push upward with basin wrench and rotate clockwise to
lock the sensor cover.
While using DC power for 8787T-C01, remove the battery
cover and put in 4 "AA" size alkaline batteries and tighten
the screws. C
While using AC power for 8787T-C03, connect solenoid
valve with control box assy, and then connect AC power
supply to AC power unit.
Install the cover as shown in the figure:
onnect solenoid valve with control box assy.
At last.
5
.
8787T-C03(
)
a.
b.
c.
(
)
8787T-C01(
)
4
5
Valve
ox
B
Tiles
1020014
Slurry
old
M
40
Slurry Mold
Short Screw M4
10
M4
10
Screw M3
8
m3
8
a
b
1020018-T01-C