-6-
INSTALLATION
1
Notice:
.
a.
See the figure
right for rough-in dimension requirement.
While installing 744T-C05(AC),chisel out the slot indicated
in the dot line area of figure right for installation of bushing.
Determine the installation location per rough-in dimensions
and the table of installation position. Chisel out a slot and
install the supply tubes. Then flush the supply tubes. The
depth of the slot is not less than 105 mm, see the figure to
the right for rough-in dimension requirement.
Installation that fails to accord with the
installation position or rough-in dimensions
may result in false operations or no
operations.
b. No light shall enter or be reflected into the
sensing window.
c.
reflectible objects in front of the sensing
window (e.g., mirror, polishing stainless
steel and some other polished plates).
d.
trong ultraviolet radiation or
electromagnetic field nearby.
No
No s
1
.
105mm
744T-C05(
)
a.
b.
c.
(
)
d.
Supply Tube (recommended inner
diameter is more than 25 mm)
(
25mm)
Battens
Nut
2
. Remove the dust-proof cover from the inlet connection of
the flushing valve. Then place the flushing valve into the
slot, adjust its level and square with battens and connect
the inlet tubes. Screw down the nut at the outlet position.
Refer to the specific rough-in of different toilets/squats for
the connection of outlet fittings.(You need to flush the pipe
before connect to the toilet sensor.)
2
.
/
(
)
58
Installation Side
100
100
100
100
130
130
Install bushing
Connector
Connect control box while
installing 744T-C05
744T-C05
Connect DC wiring terminal
Outer diameter of bushing
is no more than 25mm
25mm
1046837-T01-D
