Notice:
a. If it is necessary to set up again, you must
cut off the power supply. Repeat the above
steps after the indicator goes out.
b. If sensinng time is less than 1 min, the
sensor will flush at liquid wastes only
volume automatically.
c. When used with K-4330, the dual flushing
mode 4L/6L and single flushing mode 4L
are not recommende
d.When used with squat ,the dual flushing
mode 6L/8L and single flushing mode 8L
are recommended.
a.
b.
1
c.
K-4330
4L/6L
4L
d.
6L/8L
8L
4. Manual Flushing
This system can have a good sense toward most of the
clothes. However, it may have abnormal sense to a very small
number of clothes. If this occurs, you may use the mode of
manual flushing. Press the button with your hand to flush the
toilet bowl with water, or loosen the button to stop flushing.
a. The button is a standby device that will be
used when the sensor cannot perform
correctly or the toilet is being repaired. It is
not recommended to use when the sensor
is normally functional.
b. When the sensor cannot function properly,
please refer to the list of troubleshooting on
Page 17.
c. Do not exert too much force to avoid the
manual unit from damaged.
Notice:
Button
4.
: a.
b.
(P17)
c .
-14-
1046837-T01-D
