Kohler 4-8EFKD, Руководство по установке

Страница: 2 / 16

2 TT-1715 2/17
Carbon monoxide.
Can cause severe nausea,
fainting, or death.
The exhaust system must be
leakproof and routinely inspected.
WARNING
Carbon monoxide symptoms. Carbon monoxide can
cause severe nausea, fainting, or death. Carbon monoxide
is a poisonous gas present in exhaust gases. Carbon
monoxide poisoning symptoms include but are not limited to
the following:
D
Light-headedness, dizziness
D
Physical fatigue, weakness in joints and muscles
D
Sleepiness, mental fatigue, inability to concentrate or
speak clearly, blurred vision
D
Stomachache, vomiting, nausea
If experiencing any of these symptoms and carbon monoxide
poisoning is possible, seek fresh air immediately and remain
active. Do not sit, lie down, or fall asleep. Alert others to the
possibility of carbon monoxide poisoning. Seek medical
attention if the condition of affected persons does not improve
within minutes of breathing fresh air.
Operating the generator set. Carbon monoxide can cause
severe nausea, fainting, or death. Be especially careful if
operating the generator set when moored or anchored under
calm conditions because gases may accumulate. If operating
the generator set dockside, moor the craft so that the exhaust
discharges on the lee side (the side sheltered from the wind).
Always be aware of others, making sure your exhaust is
directed away from other boats and buildings.
Explosion.
Gasoline vapors can cause
explosion and severe injury or
death.
Before starting the generator set
engine, operate the blower 4 minutes
and check the engine compartment
for gasoline vapors.
WARNING
Ignition-protected equipment. Explosive fuel vapors can
cause severe injury or death. Gasoline vapors can cause an
explosion. USCG Regulation 33CFR183 requires that all
electrical devices (ship-to-shore transfer switch, remote start
panel, etc.) must be ignition protected when used in a gasoline
and gaseous-fueled environment.
Parts List
Two-Inch Digital Gauge
Kit: GM96999-KP1
Qty. Description Part Number
1 Decal, warning 249494
1 Gauge, digital GM95503
1 Harness, wiring GM96782
Installation Procedure
Note: Read all safety precautions at the beginning of
this publication before performing any work on
the generator set.
1. Remove the generator set from service.
1.1 Press the start/stop button to stop the generator
set. Then, press the power button to turn off the
controller.
1.2 Disconnect the generator set engine starting
battery, negative (--) lead first.