1112263-9-A
©2009 Kohler Co.
Dome
Screw
Mounting Nut
Valve Spline
Handle
Plug Button
O-Ring
Washer
Bonnet
Valve
Limit Stop
Faucet
Body
Seal
Check Valve
with O-ring
Spacer
Seal
Plug
Button
Screw
Screw
Handle
Bonnet
Handle
Bonnet
Handle
Bonnet
Handle
Bonnet
Plug
Button
O-Ring
Screw
Plug Button
Setscrew
Setscrew
SERVICE KIT INSTRUCTIONS
1108711
SPACER ASSEMBLY KIT
Place the new seal into the faucet body.
Insert the O-ring end of the new check valve into the new spacer.
Properly seat the new spacer on the seal in the faucet body.
Securely wrench tighten the mounting nut to the faucet body.
Press the limit stop on the valve spline, then position the limit stop at the mark on the valve.
Securely hand tighten the bonnet.
Reinstall the handle.
Turn on the water supply. Check for leaks and proper operation.
Install
Turn off the water supply. Lift the handle to relieve the water pressure.
Identify your handle type in the illustration, then disassemble the faucet according to the illustration.
Turn the bonnet counterclockwise to remove it from the faucet body.
Mark the limit stop on the valve to ensure correct realignment.
Slide the limit stop off of the valve spline.
Turn the mounting nut counterclockwise to remove it from the faucet body.
Extract and discard the vacuum breaker (not shown), check valve with O-ring, and seal from the
faucet body.
Remove
