4.2
Removing the Valve / Solenoid Assembly
4.2.1
Remove the burner assembly as in section 4.1
4.2.2
Remove the thermocouple retaing nut from the solenoid. remove the
main pipe, inlet pipe and pilot pipe from the solenoid.
4.2.3
Remove the solenoid retaining screws and remove. Re-assemble in
reverse order and carry out a gas tightness test. Re-fit pebbles
as shown in section 3. The Evo trim & ashpan can now be
re-positioned.
4.3
Removing the Pilot Assembly.
Note : Because this appliance is fitted with an atmosphere sensing ‘Oxy-
Pilot’ it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
4.3.1
Remove the burner assembly as in section 4.1.
4.3.2
Unscrew the thermocouple retaining nut from the solenoid.
4.3.3
Loosen the pilot nut and remove two screw retaining the pilot assembly.
4.3.4
Re-assemble in reverse order and carry out a gas tightness test. Re-fit
pebbles as shown in section 3. The Evo trim & ashpan can now be
re-positioned.
4.4
Replacing the Batteries (Within the Firebox)
4.4.1
Remove the Evo trim assy. The battery holder is located on the Right
Hand side of the appliance .
4.4.2
Remove the battery pack with care and then disconnect the battery lead
at the white rectangular plug and socket.
4.4.3
Replace in reverse order and check correct operation of the appliance.
NB
The handset uses one LR61 (9v) and should be replaced by
removing the cover on the rear of the handset.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
25
Содержание KRDPB0RN
Страница 27: ......
