- 17 -
＊Why this happens
During transportation antenna element might have come out a little because
of vibration or shock. Unless all the elements are at HOME position, you cannot
test VERSA antenna properly. Be sure to take a step described above to see as
in Figure14.
＊Numbers on the upper right corner of LCD
Each number corresponds with each element (motor) number in the LCD
display as in 「Figure14」. 3 element model should have「１２３」
、4 element
model「１２３４」
、 5 element model「１２３４５」
、and 6 element model 「１
２３４５６」.
See［Figure13、Figure14］
＊Figure13、Figure14 shows KA1-406(6element model).
#2
While pressing ②50M button, press ①POWER button.
You will see Figure15 first on LCD and then will see Figure16.
Now your controller is in the Test mode.
See［Figure15、Figure16］
→Go to procedure #3
Figure13：When you turn on the
controller, you will see above.
Model
number,
software
version, ROM version, and
available bands appear. In some
seconds information will switch
Figure14 ： You see above
information while elements are
retracted in AEU completely. We
call this status HOME position.
Figure15：When you turn on the
controller, you will see above.
Model
number,
software
version, ROM version, and
available bands appear. In some
seconds information will switch
to as Figure 16.
Figure16 ： Shown on LCD is
under Test mode.
The frequency shown is the one
used at our factory.
