Kogan SMARTERHOME KASHMFP20BA, Руководство пользователя

Страница: 20 / 24

KASHMFP20BA (2000w model)
This heater is designed to be mounted flat to the wall. Before installation please ensure that
the floor and wall are flat, and there is nothing that would prevent the heater fitting flush.
1.
The heater is designed to be permanently fixed to a wall with a minimum distance
of 300mm between the base of the heater and the floor. A distance of 600mm is
recommended for the optimum height on the wall.
2.
The upper bracket should be placed against the wall 490mm above the planned
position of the base of the heater.
3.
While ensuring that the bracket is level (using a spirit level) mark the position of the
six screw holes in the wall.
4.
Put the bracket to one side, drill the holes marked in step 3 with an 8mm drill bit to
a depth of around 35mm.
5.
Clean any dust and debris from drilling, and insert a wall plug into each hole,
ensuring they are flush with the surface of the wall.
6.
Hold the bracket in position and attach to the wall using 6 screws.
7.
Two people should carefully lift the heater into position, ensuring the top edge of
the fire engages with the bracket.
Notes:
• The wall plugs supplied are designed for solid walls, and so depending on the type
of wall, a different type of plug may be required.
• Before drilling into the wall, you must ensure that there is no pipework or wiring
behind the wall which may be damaged during installation.
• The fire must be installed by a competent person, if in any doubt about
installation, the suitability of the wall, or wall plugs supplied, professional advice
should be sought.