C. Relative altitude measurement
Press MODE button to enter relative altitude mode, press SET/HIST button to test the relative altitude of the current position. In practice, the barometric
pressure is changing constantly and the climate is unsteady, which will cause the measure error (< 100m). After setup, please put the product in different
position to measure as soon as possible, the measure result is the altitude difference between two positions.
D. Snooze function
When the alarm is sounding, the alarm clock icon will flash. The alarm will sound for 1 minute. Press the SNOOZE/DOWN button during the alarm tone to stop
the alarm clock and enter snooze. Press any other button to simply stop the alarm clock without the snooze function. During snooze, the snooze icon - “Zz” - will
flash and the alarm clock will start to ring 5 minutes later. The alarm will repeat a maximum of five times. If you press the SNOOZE/DOWN button to cancel
snooze function when snooze is operational, the snooze icon will disappear.
E. Channel inquiry and compulsory reception
- In the non-setup state, press the SNOOZE/DOWN button to switch between channels. (eg. CH1, CH2 and CH3) If only one channel is found in the search,
you will be unable to switch between channels.
- The main unit will be unable to operate or collect signals normally when there is electromagnetic disturbance, when it is low on power or positioned beyond a
certain distance. Press the SNOOZE/DOWN button lightly to check if each channel is working normally. You can press the SNOOZE/DOWN button for more
than 3 seconds to force a signal search. If the remote sensor fails to work, please check channel and the batteries. Once the issue has been addressed,
please pair the remote sensor with the main unit.
Note:
After the installation of the batteries, this item will search the remote sensor automatically/ If you are using more than one sensor, select a different
channel for each sensor.
F. Displaying moon information
- The moon state will be changed based on the time/date settings.
- When moon phase icon is in full display, this indicates a new moon. When there is no display, this indicates a full moon.
G. Displaying MAX/MIN temp/humidity
- Press the MAX/MIN button. The “MAX” icon and the maximum temperature/humidity of the day will be shown on LCD display.
- Press the MAX/MIN button, “MIN” icon and the minimum temperature/humidity of the day will be shown on LCD display.
- Press the MAX/MIN button for 3 seconds to clear the records.
- The main unit will automatically clear the records of the day's high temp/ humidity before at 8am, every morning. The main unit will also clear any recorded low
temp/humidity data at 8pm, every evening.
Ⅳ
. TROUBLESHOOTING
Problem
：
The main unit does not display temperature and humidity readings.
Solution:
1. Press and hold the SNOOZE/DOWN button for more than 3 seconds to force a search for a signal.
2. Check batteries and re-install them, firstly for the main unit, then for the remote sensor.
3. Place the remote sensor closer to the main unit and at a distance from any disturbance
4. Use new batteries if necessary. (note: do not use rechargeable batteries)
5. Position the remote sensor & the main unit in a place with minimal obstructions to assist with signal strength, avoiding doors, walls and furniture.
- 6 -
Содержание KAWTHSTATXA
Страница 1: ......
