4. Operation
Your metal detector has four operation modes: DISC, TONE, ALL METAL and
TARGET TRACK. DISC and TONE are motion modes while TARGET TRACK is a
non-motion mode.
When searching, generally set operation mode to “DISC” and to high sensitivity
position and set “DISC/TONE” to “0”. Sweep your search coil as following picture,
move the search coil back and forth in an arc line. To ensure you do not miss a
target, it is better to keep the distance from the search coil to the earth at
between about 1 – 5cm (closer to the earth for smaller target) and the distance
between two neighboring arcs at 10 – 15cm.
If there is a sound of “di-di” during moving, it indicates that there is a metal target
in the sound area. In this case, you can use “TARGET PINPOINTING” to pin-
point the target. Then use “DISC” or “DISC/TONE” to determine whether the
target is worth digging out. The followings are the four operation modes in detail.
1. TARGET PINPOINTING
If there is a sound of “di-di” during searching in DISC, it indicates that there is a
metal target in the sound area. In this case, you can use “TARGET
PINPOINTING” to pin-point the target. Hold the search coil 50cm or more away
from the earth. Hold down the TARGET PINPOINTING button, a red button at the
top of the handle. Sweep the search coil over the sound area and release the
button when you hear a sound of “di-di”. After about 1~2 seconds, hold down the
red button again, and if the “di-di” sound disappears (this means the target is far
8
Содержание KAMETANDETA
Страница 1: ......
