PickPoint-27 USER MANUAL
6.- Charging the Buoy Batteries
Page 4 of 6
To fit the buoy on the charger this must be inserted on the charging hole then just push in and
turn clockwise until the two tops inside the charging hole are inserted on to the buoy bottom
rails (Picture 4).
Charging led will become Red when the buoy is on charge and Green when buoy is fully
charged.
The GPS Buoy can be placed on the charger at any time after use.
Estimated charging time is around 8 hours (with battery level at 0%) and when fully charged the
buoy working time will be approximatly 5 days (Transmitting time every 10 minutes).
Before introducing the buoy into the charger it must be dried to prevent salt
water from accumulating inside the charger. It is also advisable to occasionally
add a little petroleum jelly over the screw on the bottom of the buoy.
Insert the
buoy on the
charger hole
Turn
clockwise
to fit
Push in and
turn
anticlockwise
Pull down to
take o ffthe
buoy
Place on charger
Take o fffrom charger
Picture 4
= Led Status, charger on and
battery full
= Led Status, charger on and
battery charging
