Koden MDC-7010, Руководство по эксплуатации

Страница: 166 / 234

Chapter 7 System and Maintenance menu operation MDC-7000/7900 Series
0093169010-10 7-6
7.9 BACKUP of Setup data (Cannot be used while transmitting)
By saving setup data to the internal memory or external memory, the initial setup and all settings are
saved, in the event that the radar needs to be reinitialized or some setup changes been made, user can
go back to the original settings by restoring from memory.
Backup of setup data should be saved after initial setup.
In case of malfunction of display where re-initialization must be done, restore of backup data completed
at the time of original setup will bring all proper settings and tuning setup back to normal operation.
Internal save of setup data
To save data internally at the time of setup,
1
Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [BACKUP] => [SETUP SAVE] => [GO], and press ENT key.
To restore from internally backup after re-initialization,
1
Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [BACKUP] => [SETUP LOAD] => [GO], and press ENT key.
External save of setup and map data
To save setup and map data externally, this information can be later used to restore after a possible
malfunction.
The external memory uses an SD memory card.
CAUTION: Please do not use the SD memory card which is loaded with software program files.
To perform external backup to SD card,
1
Insert SD memory card in the upper card reader on the rear of the Display unit.
2
Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [BACKUP] => [SD CARD] => select [SETUP SAVE], [MARK SAVE],
[TGT TRACK SAVE] or [OWN TRACK SAVE] => [CANCEL] or [GO], and press ENT key.
When SD memory card not inserted, [SD CARD] menu is greyed out and cannot be operated.
To restore from SD card backup after re-initialization,
1
Insert SD card that was used to store settings in above procedure in the upper card reader on the
rear of the Display unit.
2
Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [BACKUP] => [SD CARD] => select [SETUP LOAD], [MARK LOAD],
[TGT TRACK LOAD] or [OWN TRACK LOAD] => [CANCEL] or [GO], and press ENT key.
When SD memory card not inserted or no data found on the card, [SD CARD] menu is greyed out
and cannot be operated.