Koden ESR-145, Руководство по эксплуатации

Страница: 66 / 86

4-7
INSTALLATION
3. MOUNTING TD SHAFT INTO TRANSDUCER UNIT
•
When assembling the TD shaft into the Transducer unit, the Transducer unit must be
fixed, and screw the TD shaft into the Transducer unit.
•
Be sure not to damage the TD shaft thread or twist the Transducer unit cable.
1 - Totally wipe off dirt and grease from the threads of the Transducer unit and the TD shaft.
- Screw the Lock nut into the thread end of the TD shaft. (see figure 1 below)
2 - Pass the Transducer unit cable through the TD shaft.
- Apply some silicone adhesive (supplied) to the thread of the TD shaft.
(see figure 2 below)
3 - Fully screw the TD shaft into the Transducer unit.
- Clamp the Lock nut to the Transducer unit.
- Coat the Lock nut and the TD shaft with silicone adhesive (supplied).
- Apply the bow mark at the top end of the TD shaft. (see figure 3 below)
Care not to damage the Transducer unit cable should be taken.
Screw or unscrew the TD shaft when mounting the TD shaft into the Transducer
unit or dismounting it.
Screwing the cable causes the damage of the Transducer unit or its cable.
CAUT ION