10
Rewinding
To rewind the film, attach its end
directly to the supply reel as shown
(Figure 6) and give the reel a few
turns counterclockwise. Make sure
that the film is not twisted between
the reels.
Move the master control to the
right from the OFF position to
MOTOR. Lower the
REWIND TAB
to its
horizontal position (Figure 6 inset);
it will block the film channel.
Set the speed selector at
SOUND;
this is necessary for all rewinding.
Proper film tension will be automati
cally maintained by the take-up pulley.
When the film has been completely
wound onto the supply reel, latch the
rewind tab in its vertical position,
move the master control to OFF, and
turn off the fan switch.
FIGURE 6
,
,
/
(
After the Show
Following the projection and rewind
ing of all reels of film that are to be
·
shown:
Unplug the two power cords. Wind
the power supply unit cord around the
four feet of the unit and place the
projector power cord in the projector.
Remove the take-up belt from the
take-up pulley. Raise the take-up arm
slightly, push in the
TAKE-UP ARM
RELEASE
(Figure 7), and lower the
arm to its storage position. Swing the
supply arm backward and down as far
as it will go.
Lower the projector by turning the
elevation control counterclockwise.
Unplug the speaker cable and wind
it around its storage hooks.
Replace and fasten the projector
cover.
FIGURE 7
TAKE·UP
ARM RELEASE
