SITE SPECIFICATIONS
4
23NOV99 – SS2616-1
Electrical Requirements
Power
** Phase selection must be completed by CES personnel.
*** Outside the U.S. and Canada, amperage for the PRINTER is 16A, and the amperage for the PROCESSOR is
32A.
Note
To prevent processor failures caused by power fluctuations, purchase a Square-D Buck and Boost Transformer
(Model #500SV43F) EK Catalog #869-7799. Other transformers may not provide satisfactory results.
Within the US and Canada, the PRINTER is supplied with a 2.4-metre (8-foot) POWER CORD. The power
receptacle must be located within 1.2 metres 30 cm (4 feet 1 foot) of the rear of the PRINTER. This power receptacle
should be a dedicated line with a separate CIRCUIT BREAKER. The receptacle must accept a PLUG which
conforms to NEMA N6/15 (printer plug specification). Outside the US and Canada, the region will supply the
appropriate locally approved POWER CORD and PLUG. The POWER CORD should be cretified and approved by
a national test house.
Within the US and Canada, the PROCESSOR is supplied with a 2.4-metre (8-foot) POWER CORD which enters the
cabinet from below. The power receptacle must be located within 2.4 metres 30 cm (4 feet 1 foot) of the rear of the
PROCESSOR. This power receptacle should be a dedicated line with a separate CIRCUIT BREAKER. The
receptacle must accept a PLUG which conforms to NEMA L6-30P (processor plug specification). Outside the US
and Canada, the region will supply the appropriate locally approved POWER CORD and PLUG.
A PROTECTIVE EARTH GROUND must be supplied when installing the PROCESSOR.
Voltage Range/
Frequency***
Power Consumption
Roll-to-processor
Printer: 200-254V,
47-63Hz, 1phase, 15A
Processor: 208-254V,
47-63Hz, 1phase or 3
phase**, 30A
Less than 9.12kVA.
Roll-to-roll
200-254V, 47-63Hz,
1phase, 15A
Less than 2.4kVA.
