Kodak EKTAPRO, Инструкция по эксплуатации

Страница: 4 / 16

15
english
Important Safety Precautions
When using your equipment, basic safety precautions should
always be followed, including the following:
1. Read and understand all instructions before using.
2. Always use the correct voltage, as described on page 16.
Incorrect voltage can lead to malfunctions in the projector.
3. Close supervision is necessary when any appliance is used by
or near children, or others who may not understand the need for
the following precautions. Do not leave the projector unattend-
ed while in use.
4. Care must be taken as burns can occur from touching hot
parts. For lamp replacement let the module cool down before
touching the lamp and the surrounding area. Do not place the
lampmodule on heat sensitive surfaces (s. p. 21).
5. Do not operate projector with a damaged cord or if the
projector has been dropped or damaged - until it has been
examined by a qualified service technician.
6. Position the cord so that it will not be tripped over, pulled, or
placed in contact with hot surfaces.
7. If an extension cord is necessary, a cord with a current rating
at least equal to that of the projector should be used. Cords rated
for less amperage than the projector may overheat.
8. Always unplug the projector from the mains before cleaning
and servicing (e.g. lamp replacement) and when not in use. Never
pull cord to plug from outlet. Grasp plug and pull to disconnect.
9. Let the projector cool completely before putting away.
10. The element of a hot projector lamp is impact-sensitive!
Avoid any impacts to the projector whilst it is running and
cooling down!
11. To reduce the risk of electric shock, do not immerse this
projector in water or other liquids.
12. To reduce the risk of electric shock, do not disassemble this
projector, but take it to a qualified service technican if service
or repair work is required. Incorrect reassembly can cause an
electric shock when the projector is used subsequently.
13. The use of an accessory attachment not recommended by the
manufacturer may cause a risk of fire, electric shock, or injury
to persons. Only devices with safety-low voltage (SELV) are
allowed to be connected.
14. Connect this projector to a grounded outlet.
15. Keep air inlet (1) and air outlet (7) free from obstruction.
S
AVE THESE INSTRUCTIONS
!