Kodak Digital Science DC210, Руководство пользователя

Страница: 53 / 61

Troubleshooting 7-3
Picture is too dark. Flash is not on or
did not go off. Turn on the flash. Refer to “Flash” in
Chapter 3.
The subject is too
far away from the
flash. Move so there is no more than 10 ft (3 m)
between the camera and the subject.
The subject is in
front of a bright
light. Change your position so the light is not
behind the subject.
Picture is too light. The flash is not
needed. Change to automatic flash. Refer to
“Flash” in Chapter 3.
The subject was too
close when you
used the flash. Move so there is at least 1.6 ft (0.5 m)
between the camera and the subject.
The light sensor is
covered. Hold the camera so your hands or other
objects do not cover the light sensor.
Stored pictures are
damaged. The memory card
was removed when
the Ready light was
blinking. Make sure the Ready light is not blink-
ing before removing the memory card.
Pictures remaining
number does not
decrease. The image resolu-
tion does not take
up sufficient space
to decrease the pic-
ture remaining
number. The camera is operating normally. Con-
tinue taking pictures.
Picture is not clear. The lens is dirty. Clean the lens. Refer to “Caring for the
Camera” in Chapter 2.
The subject was too
close when you
took the picture. Move so that there is at least 1.6 ft
(0.5 m) between the camera and the
subject. Stand at least 8 in (20 cm)
away for close-ups and at least 3.28 ft
(1 m) for telephoto pictures.
Subject or camera
moved during pic-
ture taking. Hold camera steady during picture tak-
ing until after the flash (or the second
flash if the camera flash is set for red-
eye reduction).
Templates do not
work. The memory card
may not contain the
templates. Only the original memory card contains
templates. Templates are lost when the
memory card is formatted. Instructions
for replacing the templates can be
found on the Kodak Web site at
www.kodak.com .
3UREOHP &DXVH 6ROXWLRQ