8
9
Installation Precaution
Door Camera Installation
Components
Monitor and camera must be installed away from direct light
and counter light.
Camera must be installed at a place free from rain.
Standard height of monitor must be 1,450mm~1,500mm from ground
and centered around monitor screen.
Camera should be installed on the wall in which cement is completely dry.
If installed during winter season at temperature below -5
℃,
condensation
might be generated inside monitor and camera due to temperature
difference between indoors and outdoors.
To prevent breakdown due to such condensation, connection should be
made in 2 hours or more after installation.
Do not install monitor and camera in locations subject to direct heating as
harmful gases may subsequently be emitted in significant amounts.
●
●
●
●
●
●
Standard height of monitor is 1,450 ~ 1,500mm from bottom
to the center of monitor screen.
For installation, avoid the places where there is any excessive
humidity, magnetic force, dangerous chemicals, direct ray of sun,
and any places near a heater which can cause break down.
Standard Height of Monitor
Surface-mounting Door Camera Installation
●
●
Standard height of the door camera is 1,400mm~1,450mm from
the bottom of one camera to the floor.
In case that the height of Door camera exceeds the range of
min. 1,250mm~1,550mm, it is impossible to control the screen
picture with only the lens angle, and therefore, be careful of the
height of camera in installation.
Standard Height of Door Camera
●
●
Stopping up pipe as above minimizes
temperature difference between indoors and outdoors,
and also eliminates moisture and condensation on door
camera window.
※
Bottom of
1 Rectangular
switch box
Bottom base of
One hall Box
Center of moniter
(unit:mm)
(unit:mm)
Stop up P.V.C. pipe using
adiabatic substances, to prevent
air circulation
Monitor
Wall Hanger Bracket
8 Pin cable for
monitor extension
4 pin cable for camera &
sub audio phone(KDP-602G)
CCTV Camera or DVR connection cable
Door Camera
Rear Bracket
Monitor Installation
1
2
3
4
5
Rear
END
Rear
6
4X25mm
Screw
Wall hanger
pannel
3X8mm
Screw
AC type
4X25mm 4ea 3X8mm 1ea
Screws for fixing Monitor
4X25mm 4ea
4X8mm 1ea
"L" Wrench
Screws for fixing Camera
Screw cap
(Only KC-MC31)
DC15V Adapter
4Px3
8P
KC-MC30
KC-MC31
Wall
4X25mm
Screw
4X8mm
Screw
Wrench
Name plate
Wall
4X25mm
Screw
4X8mm
Screw
Wrench
Screw
cap
Standard wire strip specification : 6~7mm
Standard wire (AWG) : 16~24(0.5mm~1.2mm)
Camera Terminal Block
Camera
Camera
Rear Bracket
Rear Bracket
Standard wire strip specification : 6~7mm
Standard wire (AWG) : 16~24(0.5mm~1.2mm)
Camera Terminal Block
