KOBELT MANUFACTURING CO. LTD MNL-5022-H.docx (rev A)
19
Note:
1.
When the brake linings are replaced it will be necessary to reset the clevises by turning
inward to allow for the extra thickness of a new lining.
5.3.3
Brake Linings
The linings must be replaced before the rivets make contact with the disc. Remove worn linings
from the shoe by drilling out the rivets with a ¼” drill. Install new linings with th
e proper rivets.
LINING REPLACEMENT
1. Remove bottom cotter pins from pins
‘E’.
2.
Remove pins
‘E’ by pulling upwards.
3.
Remove shoes by sliding radially forward to
clear the ends of the levers.
When re-installing the shoes into the caliper assembly,
be sure to re-
engage the balancing links “A”.
If there is insufficient room radially to remove the shoe,
then screws ‘C’ must be removed.
BALANCING LINK ADJUSTMENT
To adjust;
1.
Loosen screws ‘B’,
2. Apply brakes onto the disc,
3.
Ensure link ‘A’ has no tension on it. Adjust if
necessary.
4.
Tighten screws ‘B’
When reinstalling the shoes and pivot blocks reinstall the shoe pin first to align the pivot blocks
before tightening screws ‘C’.
Tighten screws ‘C’ to
200 in-lbs [ 22.7 Nm].
Содержание 5022-H
