6
Preparation Before Installation
Figure 1
Figure 2
Figure 3
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
•
Decide the location of the venting pipe from the hood
to the outside. Refer to Figure 1.
•
A straight, short vent run will allow the hood to perform
more efficiently.
•
Try to avoid as many transitions, elbows, and long run
as possible. This may reduce the performance of the
hood.
•
Temporarily wire the hood to test for proper operation
before installing.
•
Important: Peel protective film off the hood, if any.
•
Use duct tape to seal joints between pipe sections.
CAUTION:
If moving the cooking range is
necessary to install the hood, turn off the power in an
electric range at the main electrical box. SHUT OFF
THE GAS BEFORE MOVING A GAS RANGE. And use
a protective covering to protect cooktop and/or
countertop from damage.
Custom Hood Preparation
1. The custom hood frame must be sized to the shape
and the weight of the insert. Refer to Measurements
and Diagram on Page 12-13.
2.
Install 6” Round Plastic Collar using 2 attached screws.
Refer to Figure 2.
3. It must have a sturdy base (1/2 inch thick plywood
recommended) to sustain the weight of the insert.
4. If an optional liner will be installed, the side of the wood
cabinet must be sturdy (1/2 inch thick plywood
recommended).
5. It is recommended to install a rear and front stud
support. Refer to Figure 3. The stud supports are
located 1-
1/2” up from the base of the wood frame.
Liner Installation (for 30” hood only)
6. The custom/wood hood must have a sturdy base to
accommodate the cut-out for the insert. The base must
be recessed to accommodate the height of the liner
(See liner dimension on Page 12).
7. Secure the liner to the bottom of the base using screws
(not included) appropriate for the size and material of
your wood frame.
8. Position the liner so that it aligns with the back edge of
the custom wood frame. Use a pen to trace the outline
of the pre-cut area. Remove the liner and proceed to
Hood Preparation before Installation on Page 7.
9. Install the liner with 5 screws (not provided)
