KOBE IN2636SQB, Инструкция по установке и руководство по эксплуатации, Страница: 9 / 80

7
before installing the insert.
20. Determine the proper location for the Power Supply
Cable. Make a wiring access hole using a drill bit.
Install the wire cable and seal the gap around hole.
21. Cut out the opening where the insert will be installed.
(Figure 5)
Hood Installation
NOTE: USE HAND TOOLS ONLY. DO NOT OVER
TIGHTEN SCREWS. IT MIGHT CAUSED DAMAGED TO
THE HOOD.
22. Remove 4 screws located at the bottom of the insert.
(Fig. 6). Slowly remove the light support panel and
unplug all the connections as shown in Fig. 7.
23. Install the hood casing support (provided in the screw
package). Adjust the level of the locking mechanism
according to the thickness of the base (3/4 thickness
plywood recommended). Tighten the screws (included)
to secure as shown in Fig. 8.
24. Install the insert inside the custom wood frame.
25. Install the insert using the rear and front mounting holes
which are located at 1-1/2” (38mm) up from the insert
base (Screws not included).
26. For a more secure installation, use the mounting holes
located on the side of the insert
27. Make sure insert is secure before releasing.
28. Re-install the light support panel. (Do not over tighten
screws.)
CAUTION
: MAKE SURE HOOD IS SECURE
BEFORE RELEASING.
Final Assembly
29. Install the oil tunnel into recess support near rear of
hood. Refer to Figure 9.
30. Install Baffle filters. Angle baffle filter toward back of
hood
①
. Push baffle filter up until almost level
②
.
Slide forward into recess behind the front of hood
③
.
Lower baffle filter
④
. Slide back until it fits into resting
position
⑤
. Refer to Figure 10.
Figure 9
Figure 10