-10-
11.
Checking
Press the TEST/ARMING button to check the function of the
internal circuitry and the condition of the battery.
twice per second and the Buzzer should also sound twice per
second.
for about 3 minutes.
If the High Bright Green leds goes off immediately , replace the
battery (see battery replacement).
If the detector still does not arm correctly, then it is faulty and
should be returned to the manufacturer for repair.
Using a known high voltage AC source.
Arm the detector if necessary.
Present the detector, armed if necessary, to a high voltage source,
touching it with the contact electrode. The High Bright Red Leds
12. Typical uses
The main function of the detector is to determine whether a
conductor is energised or de-energised so that it may be safely
earthed before commencing work.
The Detector is utilized to determine if a conductor is at a potential
(conductor to earth) higher than the threshold level for which the
detector is set.
Once the conductor is at a potential higher than the set threshold,
per second.
www.grupotemper.com
-11-
13. Instructions for use
Visual Inspection
Remove detector from its carry case then visually, inspect it. Feel it
Everything must be smooth. Should it not be the case, send the
detector to the factory to replace the case.
Cleaning the detector using a cloth
Gently, clean the detector external body, using the supplied cloth
removed.
Battery Check
Depress the Red "TEST/ARM" button, then release. The High
ok. If not, replace the battery.
Buzzer, and High Bright Red Light.
Depress and hold down the Red "TEST/ARM" button, The buzzer
If not, send the detector back to the factory for repairs.
Check the Adaptor
Make sure the adaptor is not cracked and is tightly screwed onto
the detector. Should the adaptor show any type of crack, do not
use it, as it could break while you are using it.
Only use a good quality adaptor.
www.grupotemper.com