12
OPERATING INSTRUCTIONS
10. Installing the Bit Holder
The bit holder (K) at the base of the tool can store 2
bits.
a. Align the rib of bit holder with the hole on the base of
the drill.
b. Insert the screw (L) and tighten the screw securely
with a Phillips screwdriver (not included).
Removing the Bit Holder (Fig. 10)
a. Use a screwdriver to loosen the screw (L) that
attaches the bit holder (K) to the drill.
b. Remove the screw and the bit holder.
11. Installing Bits
a. Lock the trigger switch by placing the direction-of-
rotation selector (B) in the OFF (center) position.
b. Open or close the chuck jaws to a point where the
opening is slightly larger than the shank of the bit you
intend to use.
c. Insert the bit.
d. Tighten the chuck jaws securely on the bit.
NOTICE:
Rotate the chuck body in the direction of the
arrow marked GRIP to close the chuck jaws. Do not use
a wrench to tighten or loosen the chuck jaws.
WARNING:
Make sure to insert the drill bit straight
into the chuck jaws. Do not insert the drill bit into the
chuck jaws at an angle and then tighten the chuck as
shown in
Fig. 11a
. This could cause the drill bit to be
thrown from the drill/driver, resulting in possibly serious
personal injury or damage to the chuck.
I
11
11a
K
10
K
L
Содержание KT300A
Страница 18: ...18 ...
