13
kobalttools.com
CARE AND MAINTENANCE
<RXUSRZHUWRROUHTXLUHVQRDGGLWLRQDOOXEULFDWLRQRUPDLQWHQDQFH7KHUHDUHQRXVHUVHUYLFHDEOHSDUWV
in your power tool.
NEVER
use water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth.
ALWAYS
store your power tool in a dry place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
The drill will not turn on
when the On/Off switch
is pressed.
The forward/reverse rotation
control, which is on top of the
trigger, is positioned in the lock
function.
Unlock the forward/reverse rotation
control by putting it into the required
rotation position. Push the On/Off
switch and the drill will start to rotate.
The drill stops before
the screw is completely
tightened.
The torque setting of the
E-torque selector is set on a low
torque setting.
Position 1 is the lowest torque (screw
driving force) and position 15 is the
highest torque (screw driving force).
Position 16 is for drill operation.
Regulate the E-torque selector to a
higher position to reach the best result.
Battery pack does not
hold a charge or needs
to be recharged often.
1. Battery pack has not been
used for a prolonged time.
2. Heavy working conditions
such as large screws into
hard wood.
3. Battery pack was charged
below 32°F (0°C) or above
113°F (45°C).
1. This can be corrected after several
charge and discharge operations by
charging & working with your drill.
2. Heavy working conditions will use up
the battery pack energy faster. Make
sure torque setting is correct.
3. The battery pack must be charged
between 32°F (0°C) and 113°F
(45°C) for optimal use.
