7
ASSEMBLY INSTRUCTIONS
kobalttools.com
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
High Pressure Hose Assembly
3. Screw high pressure hose (B) clockwise onto
bottom front of power washer unit (A). Pull back
collar and insert o-ring post into water outlet far
enough so collar can thread onto outlet threads
until hand tight. If it takes fewer than six turns
you have not properly tightened the high
pressure hose fitting. It is easier to position the
power washer in front of you to ensure that the
threads are started correctly. Failure to properly
tighten high pressure hose will result in the hose
slipping or popping off immediately upon turning
unit on. Do not worry about damage if this
occurs–just reinstall and take extra care when
screwing on the high pressure hose fitting.
Note
:
DO NOT
use pliers or locking pliers to
tighten.
3
A
B
4. Connect the other end of high pressure hose (B)
to spray gun (K) by inserting the brass metal tip
of high pressure hose into the fitting just ahead
of trigger guard. It will lock into spray gun with a
“click”. Confirm hose is locked into spray gun
by slightly pulling on them. The hose is now se-
curely attached to spray gun.
4
B
K
5. To release hose (B) from spray gun (K), press
button on underside of gun toward trigger
guard. The hose will slide out from connection.
2
1
5
B
K
