KoamTac SMARTSLED KDC400 Series, Руководство пользователя

Страница: 37 / 231

KDC User
YOUR
KDC
37
If scanning was unsuccessful, the user will hear two short beeps, the LEDs will illuminate red,
and the message
Failed reading…
will display. If this is the case, the user should point the
KDC at the barcode and press the scan button while trying the following suggestions:

Modify the angle of the KDC in relation to the barcode, making the angle more
wide or narrow as needed.

Modify the distance between the barcode and the KDC, moving closer or further
away as needed.

Check the option settings defined in the KDC menu section and change options as
needed.

Check to see that the barcode’s width does not exceed the light beam’s width, and
vice versa.
Read Barcodes with GPS Coordinates (KDC350G)
The KDC350G may add GPS coordinates after the barcode data. To do so, the user may
follow the below instructions.
Because of the characteristics of GPS, this function is only available when
outdoors.
1.
Go to GPS Power in GPS Menu and select Enable.
2.
Check to see if the KDC is successfully acquiring GPS data by selecting Acquire Test
in GPS Menu.
When the user selects the Acquire Test, an
‘Acquiring’
message will appear on the
screen. If this is the first test, check to make sure the ‘Acquired’ message appears
within 90 seconds of acquiring GPS signal.
3.
Go to System Config in the KDC Menu and select GPS data in Display Format.
4.
After finishing the configuration, scan a barcode as explained in 3.2.1 Reading
Barcodes.
When the user has successfully scanned a barcode, the barcode data and GPS
coordinate will appear on the KDC screen.
For more information, refer to 3.3 Menu - GPS Config (350G).
Note