Islands Collection by Knoll
®
Installation Instruction
Islands Collection by Knoll
®
March 19, 2020
Part Number: 6TD00034
Sheet 2
X-Base Conference Tables Assembly - Single-Piece Top
Reference Number: 6TD00034
6td00034_2.ai
2. Installation of Assembled
X-Base with Worksurface
(see Fig. 2)
2.1 Lay worksurface upside down on a soft
non scratching surface, rectangular
worksurface shown for example.
2.2 Center and align assembled leg over the
provided pilot holes and attach using 8
(C) screws.
Note
: Be sure to not over tighten screws into
worksurface. Overtightening the screw
can cause the hole to strip.
2.3 Repeat steps 2.1 & 2.2 for the installation
of second base.
2.4 Orient stiffeners (F) as per Fig. 2A, (open
end of stiffeners (F) goes toward middle of
worksurface).
2.5 Center the stiffeners over the provided
pilot holes, attach each stiffener (F) to the
worksurface using (E) screws.
Screw (E) quantity will vary depending on
stiffener (F) size, use all provided pilot
holes.
Fig. 2
Fig. 2A
Orient stiffeners
E
F
F
C
