3
• Ensure the RGBW LED Flex does not exceed the maximum wattage of the LEDFR6 controller
12V RGBW LED Flex - up to 288W
24V RGBW LED Flex - up to 576W
Please note: this controller contains 4 channels at a max. of 6A each
• Switch on power and test for correct operation
NOTE - LED driver voltage is dependent on the LED Flex requirement
REMOTE INTERFACE
•
Ensure the RGB LED Flex does not exceed the maximum wattage of the LEDFR5 controller
12V RGB strip – up to 108W
24V RGB strip – up to 216W
•
Switch on power and test for correct operation
PAIRING REMOTE TO CONTROLLER
•
Ensure the wiring is correct between the LED driver, LEDFR5 and the RGB LED Flex
•
Switch off the power, then switch on again
•
Press and hold key 5 (speed +) immediately after the RGB strip illuminates
•
The RGB LED Flex will flash twice to confirm pairing has been successful
UNPAIRING REMOTE FROM CONTROLLER
•
Ensure the wiring is correct between the LED driver, LEDFR5 and the RGB LED Flex
•
Switch off the power, then switch on again
•
Press and hold key 5 (speed +) immediately after the RGB strip illuminates
•
The RGB LED Flex will flash 9 times to confirm that the remote and RGB controller have been unpaired
successfully
REMOTE INTERFACE
PRESET MODES
Supplied with
1x RGB Controller
1x Touch remote control
Note - Remote requires 2 x AAA batteries (not included)
PRESET MODES
Number
Mode
1
Static colour
2
Static white
3
Colour / white static
4
Gradual change all colours
5
4 colours gradual change
6
4 colours jump
7
7 colours jump
8
Red / White jump
9
Blue / White jump
10
Green / White jump
11
Red jump
12
Blue jump
13
Green jump
14
White jump
15
Circulation mode
Supplied with
1x RGB Controller
1x Touch remote control
Note - Remote requires 2 x AAA batteries (not included)
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing.
Irreparable damage will occur if this instruction is not followed.
GENERAL
The unit should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where
facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the product.
WARRANTY
This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with the current
edition of the IEE Wiring Regulations, improper use, or removal of the batch codes will invalidate the warranty. If this
product should fail within its warranty period it should be returned to the place of purchase for a free of charge
replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement
product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior
notice.
