Knight UniTech Warewash, Инструкция по эксплуатации

Страница: 9 / 24

0900591 Rev: A (07/04) Page 9 of 24
PROGRAMMING
You may find it helpful to read through the programming instructions before getting started. This will better familiarize
you with the operation of the UniTech, and will make the actual programming go much quicker. Be aware of the
following notes.
•
If you wish to return to normal operating mode at any point during programming, hold down the ENTER button for 3
seconds to exit the programming mode.
•
While programming, if no buttons are pressed for approximately 2 minutes, UniTech will automatically return to
normal operating mode.
•
Programming changes can be made while UniTech is operating — changes will take effect immediately. This
allows you to make minor adjustments “on-the-fly” and fine tune the performance of your system.
When you’re ready to get started, hold down the ENTER button for about 3 seconds to go into the programming
mode. Release the button when you see the following display...
Continue on next page
If you wish to change the menu language, press SCROLL to advance
through the available choices until your desired language name is shown on
the display. Press ENTER to continue.
SELECT LANGUAGE:
ENGLISH
All new systems are shipped from the factory with the pass code set at 0000.
If the system is new, press ENTER to continue.
If the pass code has been changed from the default of 0000 (explained later
in this manual) use
/ and SCROLL to type in your code, then press
ENTER to continue.
ENTER PASS CODE:
0000 PRESS ENTER
Use / buttons to change the speed of the rinse pump. The pump will
begin running when either button is pressed. When the desired setting has
been reached, press ENTER — the pump will stop running, and you will
advance to the next menu.
RINSE SPEED:
50%
You will only see this display if UniTech recognizes that a sanitizer “satellite
pump” is connected. Use
/ buttons to change the speed of the sanitizer
pump. The pump will begin running when either button is pressed. When the
desired setting has been reached, press ENTER — the pump will stop
running, and you will advance to the next menu.
SANITIZ SPEED:
50%
Use the SCROLL button to choose probe or probeless detergent feed mode,
then press ENTER to continue.
DETERGENT MODE:
PROBE_