Knick Stratos PROFIBUS 2222X CondI, Руководство пользователя

Страница: 134 / 192

134 Error Messages
When one of the following error messages is displayed, the device can no longer
correctly determine the measured variable.
Error Display
(blinking) Problem Possible causes
Err 01 Sensor • Wrong cell factor
• Value out of range
• SAL > 45 ‰
• Sensor connection or cable defective
Err 02 Measured
value Sensor • Unsuitable sensor
Err 03
Tem-
perature
probe • Temperature out of range
• Temperature out of range for TC
• Temperature out of range for SAL
• Outside temp range for concentration
Err 33
Senso-
check • Short circuit in primary coil
• Short circuit of lines
Err 34
Senso-
check • Open circuit in secondary coil
• Lines
interrupted
Err 98
System
error • Memory error in device program
• Signal transmission error
• Confi guration or calibration data defective
• Completely
reconfi gure and calibrate the
device
Err 99
Factory
settings • EEPROM or RAM defective
• Error in the factory settings
This error message normally should not occur
as the data are protected from loss by multiple
safety functions.
Send in the device for repair and
recalibration.