KNF N922SPE, Перевод оригинальных инструкций по эксплуатации и установке

Страница: 8 / 36

Safety Diaphragm pump N922S_E IP54
8 Translation of Original Operating and Installation Instruction, english, KNF 318667-318664 05/21
Environmental protection Store and dispose of all replacement parts in accordance with the environ-
mental regulations. Observe the respective national and international regu-
lations. This applies in particular to parts that are contaminated with toxic
substances.
EU/EC directives/standards With respect to the Machinery Directive 2006/42/EC, the pumps are partly
completed machinery and are, therefore, to be regarded as not ready for
use. Partly completed machinery may not be commissioned until it has
been determined that the machine into which the partly completed machin-
ery is to be installed complies with the provisions of the Machinery Direc-
tive 2006/42/EC. The following fundamental requirements of Annex I of Di-
rective 2006/42/EC (general principles) are applied and observed:
§
General principles no. 1
As these partly completed machines are built-in devices, the mains con-
nections and equipment for disconnecting and switching off the partly com-
pleted machinery as well as overcurrent and overload protection gear must
be considered when mounting.
Furthermore, protection against contact with moving and hot parts, if
present, must be provided during installation.
The pumps comply with Directive 2011/65/EU.
The following harmonized standards are satisfied:
§
EN IEC 63000
§
EN 60034-30-1 (only pumps with three-phase motor)
§
EN 60034-1
Customer service and repairs The pumps are maintenance-free. However, KNF recommends periodic in-
spection of the pump for obvious changes in noise or vibration.
Only have repairs to the pumps performed by qualified KNF personnel.
Housings with electrically live components may only be opened by special-
ist personnel.
Use only genuine spare parts from KNF when performing servicing work.