24
The quantity of coolant is regulated by the water
nozzle (7-11/1).
Turning clockwise = more water
Turning counterclockwise = less water
Push the grinding lever forward with the right
hand and rotate the knife along the cutting edge
with the left hand until burr has been formed over
the entire length of the cutting edge.
If a burr has formed over the entire blade, the
grinding unit is moved to the next locking posi-
tion with the hand wheel. The knife moves in the
direction of the belt. Carry out five strokes in this
position (a stroke = grinding from the blade edge
to blade base and back again).
Then move to the next locking position and
execute five strokes again (etc.) until the entire
curvature of the knife is ground.
Then move back to position “2”. Swivel back
the belt grinding attachment including knife. The
knife can now be removed and a new one tight-
ened on.
NOTICE
The locking lever must not be pressed when
moving back to locking position 2. All the
locking positions up to locking position 2 can
be skipped by turning the hand wheel.
Knives with very pronounced corners are
only ground from corner to corner before
moving on to the next area and grinding
from notch to notch again.
Switch off the grinding machine once the grinding
process is finished.
To do so, set the “I / 0” main switch (7-6/1) to the
“0” position.
7. Operation
Figure 7-11
Water regulation on the wet-grind-
ing belt
Figure 7-12
Grinding the cutter knife
1
