7
4000 MiD® Instructions, V6695
Modifications not expressly approved by the manufacturer could void the
user’s authority to operate the equipment under FCC rules.
Subject to the Waste Electrical and Electronic Equipment (WEEE)
Directive; see WEEE compliance statement.
WEEE Compliance Statement
This statement is valid only for customers in EU member countries. The
European Union (EU) directive for product recycling (The Waste Electri-
cal and Electronic Equipment - WEEE Directive) will shortly be incorpo-
rated into the national laws of each EU member state. Products falling
under the scope of the WEEE Directive are identified with a crossed over
“wheelie” bin symbol on the product label. An authorized waste disposal
service must be used to dispose of the product for recycling or disposal,
or alternatively return the product to KNAUER.
Warning
The manufacturer’s declaration becomes invalid if the
user modifies the original product or installs additional compo-
nents.
Avertissement
La déclaration du fabricant est annulée si l’uti-
lisateur modifie l’origine du produit ou installe des composants
supplémentaires.
2.4.1 Electromagnetic compatibility
The manufacturer has tested and evaluated the MiD to ensure it fully
complies with EMC and safety standards as outlined in IEC 61010-1:
2010.
2.4.2 Precautions
The following safety precautions concerning the operation of the MiD
and the site in which it is used must be observed at all times in order to
prevent injury and damage to the system and associated instruments.
Warning
At least two people are required to lift or move the
MiD.
Avertissement
Au moins deux personnes sont nécessaires
pour soulever ou déplacer le MiD.
Warning
To prevent injury
and damage to equipment please
ensure the blanking plug is removed from the exhaust port before
activating the pumps.
Avertissement
Pour éviter blessures et dommages matériels,
veuillez vous assurer que le bouchon de fermeture soit retiré de
l’orifice d’échappement avant d’activer les pompes.
Symbols and signs
