Installation Instructions
Adjustable Glass Shelf Kit
0132-524-GL2
Tools Required (not included):
- Power Drill
- 1/16" Drill Bit or 3/16" Drill Bit
- Level
- Tape Measure
- #2 Phillips Bit
- Phillips Screwdriver
- Pencil
Installation Materials (included):
- (2) Shelves
- (4) Decorative Finial
- (4) Shelf Clamp
- (2) 18" Wall Standard
- Mounting Hardware
Load Rating:
- 50 lbs when mounted into studs
Figure 1
Figure 2
Installation:
Step 1:
Select a location to install the shelf kit. Mark the location of the top screw hole of
the left standard with a pencil.
NOTE:
For proper installation the slots located on the standards must always be facing
the left. Both standards are identical.
Step 2:
Mark the location of the top screw hole of the right standard 16" to the right of the
first mark. Use a level to ensure the standards will be the same height
Figure 1
.
NOTE:
If the standards are not being installed directly into a stud, pre-drill an anchor
hole using a 3/16" drill bit in the locations marked above. Then insert the anchors
and continue.
NOTE:
If the standards are being installed directly into a stud, pre-drill a screw hole
using a 1/16" drill bit in the locations marked above and continue.
Step 3:
Check to ensure the slots on the standards are facing towards the left, then fasten
the top screw through each standard using the screws provided.
Step 4:
Use a level to ensure that the standards are straight up and down. Then use a
pencil to mark the location of the bottom screw hole on each standard, making sure
marks are 16" apart.
Step 5:
Carefully move the bottom of the standards to the side and pre-drill the
appropriate holes
Figure 2
.
NOTE:
If the standards are not being installed directly into a stud, pre-drill an anchor
hole using a 3/16" drill bit in the locations marked above. Then insert the anchors
and continue.
NOTE:
If the standards are being installed directly into a stud, pre-drill a screw hole
using a 1/16" drill bit in the locations marked above and continue.
Step 6:
Carefully move the standards back to the straight up and down position. Then
fasten the standards to the wall using the screws provided.
Slots to
the left
Top
screw hole
16"
Level
Slots to
the left
Slots to
the left
Slots to
the left
Pre-Drill Hole
Level
