EN - 13
Device-specific additional instructions for nailer
3418...1
5
Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1) with each other.
•
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position (Chap. 4): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger and/or release protection.
•
Press locking lever and pull the magazine top backwards.
•
If required, empty the magazine:
Never have nails and staples simultaneously in the magazine!
•
Insert fasteners; if required observe filling markers:
•
Insert nails centrally, point first, into the magazine. OR
•
Push staples into the magazine over the ridge.
•
Insert magazine until it locks.
6
Adjusting drive-in depth
•
Reduce pneumatic operating pressure as far as possible to minimize blowback,
noise and air consumption (see General operating instructions).
Mechanical adjustment of drive-in depth:
•
Disconnect nailer from pneumatic supply.
•
Turn adjustment ring ('
qu
' in Fig. 1 right) with supplied hexagon screwdriver or
with pin (max. diameter 4.5 mm (0.18 in)).
Each turn from hole to hole equals a height change of 0.2 mm (0.01 in); max.
possible height change is 6 mm (0.24 in).
Turning to the right increases the drive-in depth, turning to the left decreases it.
•
Check current setting: It equals the distance between the screw head and the
flange's contact surface. (max. distance = 6 mm; greatest drive-in depth)
7
Removing stuck fasteners from the driving channel
In case of a deformed and/or stuck fastener in the driving channel:
•
The driving channel's front is elastic. A stuck fastener will widen the channel, and
ideally the fastener falls out.
If this is not possible or not sufficient, open the driving channel:
•
Disconnect nailer from pneumatic supply.
•
Hit driving nose
slanted
and with moderate force onto a wooden surface
(see Fig. 1), to open the guide plate (
'c'
in Abb. 1).
•
Remove fasteners.
•
Hit driving nose
vertically
and with moderate force onto a wooden surface
(see Fig. 2), to close the guide plate.
•
Completely empty the magazine.
•
Carefully re-connect nailer to pneumatic supply.
8
EU Declaration of conformity
The Joh.
Friedrich
Behrens AG, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
-------------------------------------------------
-----------------------------------------------------------
Tobias Fischer-Zernin, Management
Joachim Bauer, Documentation responsible
Содержание 12000556
Страница 9: ......
