KMC Controls SimplyVAV BAC-8001, Руководство по применению и установке, Страница: 21 / 75

Se c t i o n 4: C o n f i g u r i n g t h e c o n t r o l l e r s
This topics in this section are advanced topics for control technicians and engineers.
The configuration functions that are accessible through an STE-8000 series digital sensor
are all of the values and settings that are entered during the installation and commissioning
of a VAV terminal unit. Typically, these functions do not change after the installation and
commissioning process.
To set up the configuration functions, you will need the following items and information.
l
Details about the VAV terminal unit including the configuration for fans and reheat.
l
An STE-8001 or STE-8201 digital sensor to use as a configuration tool.
l
The building automation system plans for controllers connected to a network.
Users may change the active heating and cooling setpoints without accessing the
configuration functions. This procedure is covered in the topic
Changing the room
setpoint on page 19 .
Note: The instructions for the configuration functions cover all of the functions that a digital
sensor can set up in the SimplyVAV series of controllers. Not all functions are available on
every model of controller.
Configuration topics
Getting started with configuration 21
Entering system temperature setpoints and limits 23
Configuring the VAV Box options 27
Set the airflow setpoints 29
Advanced options 33
Restore Application 35
Getting started with configuration
For access to the configuration functions you will need the Password 2.
l
If the controller has not been previously set up, no password is required.
l
A new Password 2 can be entered or changed in the advance functions. See the topic
Advanced options on page 33 .
SimplyVAV
Revision H 21