Assembly Instruction
1. Put M8x35mm bolt (Part 15) on front
stabilizer
（
Part 3
）
, fingers hold the bolt bottom, put the front
stabilizer
in the front hole at the base of main frame (Part 1), add spacer and M8 cap nut (Part 15) in bolt,
then tighten it with open spanner(Part 13). Use the same way to install the rear
stabilizer(Part 2)on main
frame
.
2.
Take out the pedal (Part 16), there is superscript “L”&“R” on the pedal, take out “R” pedal and screw out
the nut from the bolt, then screw the bolt into the nut of“R” crank on main frame. After tighten it in
clockwise with open spanner, screw the nut into the bolt again to ensure the pedal assembled in the “R”
crank firmly. Take out pedal belt, buckle it up on pedal as picture shows. Take out “L” pedal, use the
same way to assemble it into “L” crank, the bolt of “L” pedal is screwed into the nut of “L” crank should
be in counter clockwise direction.
Note
:
“L”&“R”are marked on crank as well. Please install pedal accordingly, otherwise it will damage
the product. And please fasten the feet strap, or it will fall down after long usage.
3. Take out the saddle (Part 6), connect seat post (Part 7) and seat adjustable post (Part 5) together by the
plum-head bolt which screwed on seat post, then adjust the angle of saddle and assemble it into seat
post (Part 7) by tightening the nut on the saddle with open spanner. Insert the post to the back tube of
main frame, and adjust the saddle to appropriate height, then fix the post to the tube of main frame with
ball pin (Part 10) and fasten it with screw knob (Part 11).
Note: Saddle can also be adjusted back and forward by the plum-head bolt.
Note: the foot pad on front and rear
stabilizer can be adjusted to keep the
product stable on the floor after fully
assembled.
