Page 4 of 13
Intended Use
One of the most commonly used air line accessories, regulators are used to maintain a steady outlet
pressure, unaffected by variations/fluctuations in the inlet pressure. Regulators step down the air line
pressure and can be set at any desired pressure below the inlet air pressure. With an aluminum die
cast body, these are designed with a non-
raising “press to lock” adjusting knob for locking at any set
pressure. Regulators work on a diaphragm operated, relieving mechanism with pressure
compensated by a balanced poppet. These can be installed in any position.
WHY USE A REGULATOR?
Air regulators are used to provide a controlled and consistent air supply as required by different
pneumatic equipment. The knob can be used to adjust the air supply thus resulting in increasing or
decreasing the air pressure.
WETTED COMPONENTS
Aluminum, Brass, Steel, Acetal, Stainless Steel, and Nitrile
STANDARD CONFIGURATION
Pressure adjustment range of 7 - 145 PSI (0.5 - 10 BAR)
OPTIONAL CONFIGURATION
Custom built includes the following pressure adjustment ranges:
3 - 28 PSI (0.2 - 2 BAR)
3 - 58 PSI (0.2 - 4 BAR)
8 - 100 PSI (0.5 - 7 BAR)
Technical Specifications
Part #
Port
Size
Flow Rate (Max)**
Pressure Gauge
Port Size
Height
Width
CFM
LPM
Inch
mm
In
mm
57392
½”
140
4000
1/8”
6.5
165
2.75
70
Important Safety Information
⚠
WARNING
Read and understand all instructions. Failure to follow all instructions may result in serious injury
or property damage.
The warnings, cautions, and instructions in this manual cannot cover all possible conditions or
situations that could occur. Exercise common sense and caution when using this tool. Always be
aware of the environment and ensure that the tool is used in a safe and responsible manner.
Do not allow persons to operate or assemble the product until they have read this manual and
have developed a thorough understanding of how it works.
Do not modify this product in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the product. There are specific applications for which the product
was designed.
Use the right tool for the job. DO NOT attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. It will
be a safer experience and do the job better at the capacity for which it was intended. DO NOT use
Содержание 57392
Страница 10: ...Page 10 of 13 Parts Diagram...
