3
The appliance should be transported in the vertical position. The
manufacturer will not be responsible for any damage of the appliance that
results from non-compliance with the instructions for transportation.
The manufacturer guarantees reliable operation of the refrigerator when
the relative air humidity not greater than 70 per cent and the ambient
temperature is: +16 to +32 degrees Celsius - climate class
N
;
+16 to +38 degrees Celsius - climate class
ST
.
INSTALLATION AND OPERATING CONDITIONS OF THE
APPLIANCE
Positioning:
•
This appliance can be installed in a dry, well ventilated indoor where the ambient
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
WARNING! Do not install this appliance in areas that are too humid or
too colds, such as the construction appendices, garages or wine cellars.
The rear wall of the refrigerator, in particular, the condenser and other elements of the
cooling system must not contact other elements, which may damage them, (e.g. central
heating pipes and the water supply pipes).
WARNING! The appliance must not touch any pipes for heating, gas or
water supply, or any other electrical devices.
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned
distances, provide an appropriate insulation board
•
Do not cover the ventilation holes at the top of the appliances – it
must be a good air circulation
around the appliance. There should
be a gap of at least 10 cm between
the top of the appliance body and
any furniture that may be above it
(see fig.). If this requirement is not
followed, the appliance consumes
more electrical energy and its
compressor may overheat.
•
If the appliance is placed in a corner, a gap must be left
between the appliance body and the wall so that the
freezer compartment door can be opened enough to
pull out the frozen product drawer (see picture).
