KLUBB KAT 42, Руководство пользователя

Страница: 38 / 56

35
A. Emergency stop button: This is used to stop the machine in situations of imminent risk, deactivating machine operation
and the source of power in use (electricity or engine).
B. Three - position changeover switch: This is used to set the operation mode.
Position (1): This activates the outrigger controls
Position (2): This activates the upper controls (basket) controls
Position (3): This activates the lower controls
C. Engine start/stop: This is used to start or stop the vehicles engine.

Up position: Engine start

Down position: Engine stop
D.1

Horn switch: This is used to sound the vehicle’s horn to alert people nearby to the machine’s presence or the
operator’s intention to manoeuvre it.
D.2

Emergency pump: This is used to electrically retract the boom in the event of hydraulic pump failure.
Note!! The machine cannot be started from the control panel on the ground if the machine has not been stabilised
(it can only be switched off).
E. Warning outriggers reset light: This light will illuminate and a buzzer will sound to warn that the front outriggers are not
stable when basket is in operation. If this light illuminates and the buzzer sounds, you must reset the outriggers.
F. Outriggers un - stowed light: When the outriggers are out of the rest position, this light will illuminate.
G. Signal lights (green): When lit permanently, this shows that the associated outrigger is resting correctly on the ground.
Signal light 1: LH front outrigger
Signal light 2: RH front outrigger
Signal light 3: RH rear outrigger
Signal light 4: LH rear outrigger
If any of these lights are off, it means that the associated outrigger(s) is not resting properly on the ground.
1
C
4.3 MAIN CONTROL BOX
B
A
2
3
D
E
F
G
www. duma -rent.com