INSTALLATION
KI-102 | KI-172
The optional SB-102 accessory bracket is specifically designed for the KI-102 and KI-172
loudspeaker systems. The bracket provides up to four attachment points to the securing
surface and two attachment points to the speaker. When installing the bracket, the
attachement point (2” x 4” stud, Unistrut, “I” beam, etc.) must be made with bolts that
will securely hold the bracket to the mounting surface, which must be load-rated to hold
the speaker safely in place.
After the bracket is installed, mount the speaker to the bracket by first removing the
factory-attached screws on the top and bottom of the speaker. The bracket comes with
two 1/4” 20-thread knobs and washers, which will attach the bracket to the speaker. Slide
the speaker over the bracket and align the hole in the bracket with the threaded hole in
the speaker. Attach the knob screw and washer provided, and secure the screw. Do the
same to the bottom. Adjust the angle of the speaker to the desired location and tighten
both knob screws.
On the KI-172, additional internal mounting bolts are installed for the attachment
of readily available Omnimount
®
and other compatible brackets. Before completing
any installation using these devices, be sure that all hardware is firmly attached and
tightened, as recommended.
