Klip Xtreme KPM-580W, Руководство по установке

Страница: 6 / 21

Step 4
Attaching the projector plate
Step 1
Thread the selected hardware into each mounting point of the projector, making sure to use the
correct screw size.
Step 2
Drill a hole at each mark using the appropriate masonry bit for your anchor.
Remove nut and washer before inserting a concrete anchor into each hole.
If necessary, a hammer can be used to lightly tap each wedge anchor into place, so that they are
flush with the ceiling.
Step 3
Once all the anchors are in place, move the ceiling plate back into position.
Attach the nut onto the threaded shaft that is protruding from the ceiling.
Do not tighten until all nuts are in place.
Do not over tighten the wedge anchor nuts.
If applicable, drill a hole above the mounting hole for wiring access.
Step 2
Step 3
Step 4
Step 1
M6x10mm screws