REV: IR 02/15/2022
28
RNGR-102-1/220
Installation & Operation Manual
NOTE
: For vehicles with OEM / Factory upfitter
switches:
If your vehicle is equipped with factory upfitter (i.e., auxiliary) switches, you may elect to use one of them for
your Kleinn Air Horn kit. Consult your owner’s manual, or dealership, for further instructions on what wire
terminals/fuse block location to use and what programming may be required.
9.5
Connect Pressure Switch
1.
Route wiring as desired to the air tank and connect to the pressure switch per wiring diagram.
NOTE
: Either pressure switch wire can be connected to relay or ignition.
9.6
Connect Air Compressor
1.
Route wiring as desired to the air compressor and connect per wiring diagram.
9.7
Connect Air Horn Solenoid(s)
1.
Route wiring, as desired, to the air horns and connect to the solenoid(s), per wiring diagram.
NOTE
: Either air solenoid wire can be connected to power (PWR) or ground (GND).
9.8
Secure Wiring to Vehicle
1.
Insert all wiring into included wire loom and ensure loom is away from all sharp edges, hot/moving vehicle
parts, (i.e., exhaust, engine, radiator).
2.
Fasten loom securely to vehicle using supplied zip ties or equivalent.
END OF SECTION