REV: IR 02/15/2022
20
RNGR-102-1/220
Installation & Operation Manual
2.
Review included directions in the
compressor package pertaining to the remote air filter; select location on vehicle where to mount the air
filter, or if desired, filter housing may be secured to included brackets using zip ties.
3.
Pry open plastic air filter housing and install the foam filter inside. Attach fittings for filter to the end of the
air compressor and filter housing. Follow instructions included in the compressor package.
NOTE
: The air filter tubing is rigid and may be difficult to route without kinks or install over fittings. If necessary,
use a heat source (heat gun or similar) at a safe distance to make tubing pliable for routing & installation on
fittings.
Figure 8: Remote Air Intake w/ Tubing (For Compressor)
7.4
Assemble Air Compressor to Compressor Bracket
1.
Apply Air Horn Juice to the male threads on the 1/4" NPT check valve at the end of the compressor leader
hose. Thread the 51414F (
) on to the end of the check valve.
2.
Use the hardware included with the compressor to attach the compressor to the bracket as shown.
Figure 9: Air Compressor Attached to Compressor Bracket