Klein + Hummel M 50 Скачать руководство пользователя страница 3

Always check before connecting the power cable to the
mains socket that the power switch on the unit itself is set
to off ("O").

Use the power cable or power supply that came with the
unit to connect to the mains socket (wall outlet).

Power supply: a damaged power cable may not be repaired.
Use a new cable.

Avoid plugging the mains cable into a power strip that
already has several other power-consuming devices
connected to it.

Avoid using extension cables. The unit must be connected
to a mains socket close to it, and that socket should be
freely accessible.

Installation:

This product may only be placed on a stable, clean, hori-
zontal surface.

Do not expose this product to vibration.

Do not operate this product anywhere near water or other
liquids. Do not use it near a sink, swimming pool, bathtub,
or in any damp room or area. Electrical shocks carried
through water can kill. Do not place any beverages
whatsoever on or near this product, as liquids can kill
electronic components.

Ensure sufficient ventilation around the product to allow
for adequate heat dissipation, especially near the rear panel
and the sides of the cabinet (minimum of 8 inches from the
nearest wall). The unit may only be installed in a rack if
measures are taken to ensure sufficient ventilation and if
the mounting instructions of the manufacturer are followed.

Do not block or cover any heat sink, fan, or vent.

Do not place the product where it will be in the path of
direct sunlight, and keep it a safe distance away from
radiators and other heaters of any kind.

If you bring this product from a cold environment into a
warm one (such as from a vehicle into a studio), it is quite
possible that condensation will form inside the cabinet.
Please allow the unit sufficient time for acclimatisation to
room temperature (minimum thirty minutes) before
connecting and powering up.

To avoid accidents, do not use any accessory equipment
with this product which is not approved by the manufacturer,
particularly mounting accessories. Do not place this unit
on any unstable platform, cart, stand or table. Should the
unit fall, it can cause bodily injury to persons, or can be
damaged itself.

To protect this product from lightning damage during a
thunderstorm or from power surges during an extended
absence, disconnect the power cable from the wall outlet.

Fig. B

Fig. A

Always check before connecting the power cable to the
mains socket that the power switch on the unit itself is set
to off ("O").

Use the power cable or power supply that came with the
unit to connect to the mains socket (wall outlet).

Power supply: a damaged power cable may not be repaired.
Use a new cable.

Avoid plugging the mains cable into a power strip that
already has several other power-consuming devices
connected to it.

Avoid using extension cables. The unit must be connected
to a mains socket close to it, and that socket should be
freely accessible.

Installation:

This product may only be placed on a stable, clean, hori-
zontal surface.

Do not expose this product to vibration.

Do not operate this product anywhere near water or other
liquids. Do not use it near a sink, swimming pool, bathtub,
or in any damp room or area. Electrical shocks carried
through water can kill. Do not place any beverages
whatsoever on or near this product, as liquids can kill
electronic components.

Ensure sufficient ventilation around the product to allow
for adequate heat dissipation, especially near the rear panel
and the sides of the cabinet (minimum of 8 inches from the
nearest wall). The unit may only be installed in a rack if
measures are taken to ensure sufficient ventilation and if
the mounting instructions of the manufacturer are followed.

Do not block or cover any heat sink, fan, or vent.

Do not place the product where it will be in the path of
direct sunlight, and keep it a safe distance away from
radiators and other heaters of any kind.

If you bring this product from a cold environment into a
warm one (such as from a vehicle into a studio), it is quite
possible that condensation will form inside the cabinet.
Please allow the unit sufficient time for acclimatisation to
room temperature (minimum thirty minutes) before
connecting and powering up.

To avoid accidents, do not use any accessory equipment
with this product which is not approved by the manufacturer,
particularly mounting accessories. Do not place this unit
on any unstable platform, cart, stand or table. Should the
unit fall, it can cause bodily injury to persons, or can be
damaged itself.

To protect this product from lightning damage during a
thunderstorm or from power surges during an extended
absence, disconnect the power cable from the wall outlet.

Fig. B

Fig. A

Содержание M 50









Отзывы: