11
Cleaning and maintenance
Cleaning should be carried out when the appliance is COOL AND SWITCHED OFF AT THE MAINS
SUPPLY. Always clean off spillage as quickly as possible to prevent baking on which will make
removal more difficult. Wash with a clean cloth soaked in hot soapy water, rinse and dry with a
soft cloth. Do not use abrasives, caustic pastes or sprays, coarse cleaning pads or powders. Do
not use excessive water when cleaning your oven in order to avoid water passing through clefts
into the back of controls panel or of the unit.
A steam cleaner is not to be used for cleaning this appliance.
The oven accessories (shelves, grid, oven shelf carriers) and the oven door also, can be removed
for easier washing, to be done with a mild detergent solution. The slots in the front of the appliance
for the passage of the air must be carefully kept unobstructed for an efficient cooling of the unit.
Install shelves by locating them in the horizontal guide rails on the oven walls.
The raised portion of the shelf is to be facing the rear wall of the oven.
Oven door removal and refitting
Open fully the oven door and hook the ring A to the upper bar of the door hinge as shown in
fig 6. Once hinge is locked into place, grip both sides of the door, near the hinges, then lift and
remove as shown in fig. 7. After cleaning refit the oven door inversely proceeding in a similar way.
make sure the lower bars of the hinges are correctly placed in the proper slots and the rings A
released from the upper bars before closing the door.
Oven bulb replacement
Switch off your oven and isolate the power. When the oven is cool, unscrew light glass cover as
shown in fig 8. Replace the bulb with a new one of the same specifications and screw the cover
until is hand tight. Bulb replacement is not covered by your Warranty.
A
Fig. 6
Fig. 7
Fig. 8
