Kleenmaid RHWMDB40, Инструкция по эксплуатации и гарантия

Страница: 11 / 16

*Filter alarm:
The first thing to do after inserting the plug is to set the rangehood to vented or recirculating mode; proceed as follows:
when the plug is inserted, all the lights turn on for several seconds: in this state, press the on/off button for about 8 seconds
until the H LED lights. Then press B if you want the rangehood to operate in vented mode (in this mode, the carbon filter count is
not working because there is no filter); the red LED of the H filter light flashes and you confirm the selection by pressing it.
To set the rangehood to recirculating mode (and, thus, with counts for both the grease filters and the carbon filters), about
8 seconds after turning it on, press C and the red light of the H filter hood will turn steady on; press it to confirm.
After 30 hours of operation, the H button will turn steady on: this means that it is time to remove and clean the grease filters.
If the rangehood is in recirculating mode, after 140 hours of operation, the H button will flash: this means that it is time to
replace the carbon filters. To reset the count, press the H button for 7-8 seconds.
The filter hour count cannot be reset until the system turns on one of the alarms. So it is not possible to perform intermediate
resets.
OPERATION OF THE REMOTE CONTROL
(if provided)
A
B
C
D
A) Turns the rangehood on/off at the second speed
B) Decreases the speed of the motor
C) Increases the speed of the motor
D) Turns the lights on/off. (The intensity can only be regulated manually directly on the rangehood)
MAINTENANCE
Turn off the electricity before performing any maintenance or cleaning!
Cleaning the rangehood:
Clean the rangehood at least once every 2 months to avoid the risk of fire; to clean the external body, use a cloth wet with
warm water and a neutral detergent, or products specifically made for stainless steel. To clean inside the rangehood,
use a cloth wet with denatured alcohol.
Do not use abrasive or corrosive products!
Cleaning the grease filters (on both the vented and recirculating rangehood versions)
Cleanthe grease filters at least once every 2 months to avoid the risk of fire (however, the frequency of cleaning depends on
how intensely you use the rangehood).
To remove the grease filter, use the handle on the filter.
Wash with neutral detergent by hand or in the dishwasher. Keep in mind that washing in the dishwasher could discolour/
darken the filters without, however, reducing their effectiveness.
Replacing the carbon filters (recirculating version only):
Replace the activated carbon filters at least once every 6 months to avoid the risk of fire (however, the frequency of cleaning
depends on the intensity with which you use the rangehood).