Kleenmaid Rangehood Collection, Инструкция по использованию и гарантийные обязательства

Страница: 9 / 12

8
a
b
c
d
e
f
g
h
SET-UP
To access the set-up mode
•
Press knob 7 and switch the cooker hood to (OFF- all the led’s
are turned off).
• Keep button 5 pressed and press knob 7.
To exit the SET-UP mode
•
Press knob 7 again.
To enable the saturation device for the active carbon filter
Upon entering the SET-UP mode, turn knob 7 clockwise until the
LED (e) turns on. If the LED is red, depress button 5 once, the
LED (e) will turn green which will indicate that the saturation
signal device has been enabled for active carbon filter, press
again to disable (LED (e) will turn red).
To carry out manual calibration
Upon entering the SET-UP mode, turn knob 7 clockwise for one
click (about 10°) until the LED (c) turns on (red LED).
Press knob 7 to carry out manual calibration.
Additional information:
When rotating the knob clockwise in SET-UP mode, if the LED
(g) turns on then ignore it.
If the Rangehood fails to operate correctly, briefly disconnect it from
the mains power supply for almost 5 sec. by pulling out the plug. Then
plug it in again and try once more before contacting the Technical
Assistance Service.
Use the high suction speed in cases of concentrated kitchen vapours.
It is recommended that the cooker hood suction is switched on for 5
minutes prior to cooking and to leave in operation during cooking and
for another 15 minutes approximately after finishing cooking.
INSTRUCTION ON MOUNTING AND USE