Kleenmaid KFL1600, Инструкция по эксплуатации

Страница: 8 / 36

130715
Partial Aqua-stop (water stop system)
In case of damage to the interior hose, leaking is
prevented by an automatic closing system which
stops water inlet to the machine. In such cases
display A turns red.
Inlet hose must be replaced.
•
Fix the outlet hose to the wall drain outlet
(diameter min. 4 cm).
•
Wall drain must be installed properly and must
enable occasional cleaning.
•
Fasten the outlet hose support with a piece of
rope led through the hose elbow to prevent the
hose from slipping to the
fl oor.
The end of the outlet hose should be
placedbetween minimum 60 cm and maximum
100 cmabove the
fl oor level.
Connect the appliance to the power supply with the
cord provided.
A three pin, switched, earthed power point less than
1500 mm from the back of the machine is required.
Rated voltage, frequency and other data are listed
on the rating plate on the back of the machine.
Check that the supplied electrical voltage is the
same as on the rating sticker.
Your washing machine should be earthed and
connected to the power supply according to local
electricity supplier regulations and standards.
If the supply cord of this appliance is
damaged, it must be replaced by the special
cord, part no. G 360440, available from your
nearest spare parts centre (refer to guarantee
and service guide).
8
Connection to Power
Supply
Water outlet connection