Kleenmaid KCDV60, Инструкция по использованию и гарантийные обязательства

Страница: 9 / 16

13 14
MAINTENANCE
MAINTENANCE
Filter clean
•
•
•
Clean the lint filter after each use.
Remove by pulling straight up.
Cleaning filter
Use wiping cloth or your fingers.
Install filter
If the filter is cleaned by damp cloth
or water, please install after
drying in the sun.
Cleaning cabinet and inner tube
•
•
•
•
•
Use soft damp cloth wipe
cleaning cabinet and inner tube.
Do not
rinse
directly with
water.
Do not
use neutral scour wipe.
Do not
use gasol
i
ne
or
alcohol wipe
s
.
Make sure
to
open the front door for aeration after
cleaning the inner tube.
Safety reset
1.
These dryers have a safety cut out switch which is activated by temperature.
2.
The safety reset button is on the backboard. If your dryer
is
not heating this button
must be reset before the dryer can heat again. You may need to wait 10 minutes for
cooling down.
3.
The most common reason for the dryer
to
overheat is a blocked filter.
4.
Clean the line filter after each load to prevent overheating of the dryer
The cut out switch may operate for the following reasons:
1.
Lint filter is blocked.
2.
Exhaust outlets blocked at the back of the dryer.
3.
Poor ventilation in the laundry or room - open a window or door
.
4.
Lightweight garment eg. handkerchief, sucked over the filter.
Cleaning And Care Safety Reset Button
Use your finger or a pencil to press the button in until you feel it click.
Trouble Cause Solution
Will not start
External hot or
can smell hot
Clothes too dry
Clothes shrink
Hairball on
clothes
Power cut.
The power plug is not
plugged
in firmly.
Dry clothes exceed
weight
.
The temperature fuse is cut.
The lint filter is dirty.
The uptake or exhaust duct is
dirty.
Too many clothes in dryer.
Leaving clothes in the dryer
when the cycle is finished.
The clothes
are not sorted
properly.
The temperature is
set
too
high.
Too dry
.
Synthetic fibre and
permanent press fibres rub
together, causing hairballs
on fabric.
Wait
for
electricity
supply to resume
.
Check the power socket, make sure plug tight.
Place
clothes in drier
after spinning in washing
machine. C
lothes can not exceed 7kg. P
Replace
the temperature fuse.
C
lean the lint filter
after each use
.
Clean out the stem.
Make sure the
dryer is
not too full
.
Take out the clothes immediately when finish.
See page
10
.
Observe the maintenance label on clothes.
Observe the maintenance label on clothes.
I
f they shrink easily take the
clothes
out
when
slightly damp and
hang the clothes until full
y
dry.
Use dryer net bags to reduce the amount of
contact between these types of items.
Use
fabric softener
to
lubricate fibre
s.
Trouble Shooting